The operations other shops leave for you to sort out.
Tapping, drilling, grinding, deburring, assembly and laser marking in-house, with anodize, passivation, plating, heat treat and NDT coordinated through approved sources.
A machined part is rarely finished when it leaves the spindle. Rather than hand a customer a box of parts and a list of vendors to chase, we carry the balance of the operations — and the paperwork that goes with them.
In-house: tapping and drilling cells, grinding, hand and machine deburring, light assembly, and permanent laser marking on two OMTech Galvo 2-X systems for part numbers, serialization, logos and data matrix codes.
Coordinated outside: anodize (Type II and III), chemical film, passivation, plating, black oxide, heat treat, shot peen and NDT through approved processors, with certifications collected and supplied against the shipment. One purchase order, one delivery, one set of documents.
- Laser marking
- Serialization, logos, data matrix, UID
- Finishing coordinated
- Anodize II/III, chem film, passivation, plating
- Heat treat
- Coordinated through approved sources
- Documentation
- Processor certifications supplied with shipment
- OMTech Galvo 2-X laser marking systems (2)
- Dedicated tapping and drilling cells
- Surface grinding
- Deburring, finishing and light assembly stations
- Approved outside processors for finishing, heat treat and NDT
- 01
Routing built at quote
Every downstream operation is priced and scheduled up front, not discovered later.
- 02
In-house operations
Tapping, grinding, deburring, marking and assembly on our floor.
- 03
Outside processing
Approved processors only, with certifications collected on return.
- 04
Final inspection
Parts re-inspected after finishing, because finish changes dimensions.
Secondary Operations, answered plainly.
Do you handle anodizing and plating?
We coordinate them through approved processors and inspect the parts again on return, so you receive finished parts and the certifications together.
Can you laser mark serial numbers?
Yes — sequential serialization, data matrix codes, logos and UID marking on two Galvo systems.
Can you kit or assemble?
Light assembly and kitting, yes. Send the assembly drawing with the RFQ.
CNC Milling
Ten vertical machining centers running prototype through production quantities, with milled features held to a standard ±.001 in and critical callouts to ±.0001 in where the print requires it.
View capability →CNC Turning
Eight turning centers, several with Y-axis and sub-spindle, so a chucked part is turned, milled, drilled and finished on the back side without leaving the machine.
View capability →Swiss Turning
Sixteen Swiss-type lathes — Citizen L12, L20 and L32, Citizen/Miyano BNX and BNA, Tsugami S205-II and B0325V-II — holding ±.0005 in on turned diameters with as-machined finishes that rarely need a secondary operation.
View capability →